Displine PoE manual
Please make sure to use PoE+ or IEEE 802.3at, otherwise it will not work properly
On this page we have created instructions for the correct installation of our Displine PoE Converter 22W. Please read the instructions carefully so that possible problems can be avoided directly.
1. There are two USB-C ports available. The attached sticker provides information about which port represents which functions. Both ports offer the so-called fast charging function, but only the right port supports the simultaneous transmission of data - if the end device supports it. Apple iPads with USB-C port, Microsoft Surface Go and Samsung Tab A7 / A8 are compatible.
2. Please always connect the LAN cable to our Displine PoE Converter 22W first. Only then should a connection to the tablet be established.
3. If an iPad is used, the “Accessories” setting must be activated under “Face ID & Code”, this can be seen in the following screenshot.
bug fixes
1. If there is a connection error, please rotate the cable inserted into the PoE converter by 90° and try again.
2. If the charging process does not start or there is no data transfer, turning the cable can help despite the rotationally symmetrical assignment of the USB-C connector.
3. If the tablet has a dead battery and supports fast charging function, the Displine PoE Converter 22W may produce some heat. However, this is harmless and has no tangible impact on the service life.
4. The Apple Lightning to USB-C cable can deliver power, but is not optimized for simultaneous data transfer. Therefore, an alternative cable must be used here.
5. The Displine PoE Converter 22W is not designed to use both USB-C ports at the same time. Therefore only one of the two ports can be used.
6. If an iPad is used and no data is transferred after the display turns off automatically and logs in again, the following settings can help : Settings - Display & Brightness - Auto Lock - Never. It should be borne in mind that this gives everyone access to the tablet.